Efficient 4-Point Radon Mitigation System Installation

This project required a 4-point radon mitigation system to address four separate chambers within the home. Our team designed a straightforward layout with clean branch lines to each extraction point, ensuring effective coverage throughout the basement. The system exits on the same side of the home as the woodshop blower motor for an efficient setup. The homeowner will be handling the electrical work, so we’ll stop the wire outside and walk him through the final connections. With clear planning and collaboration, this system will provide strong protection against radon exposure.

This was a genuinely nice woman to talk to, really calm. It was a straightforward radon mitigation system to install and nothing too shabby. She was really interested in how it works to protect her health and home. We originally quoted her 4 years ago and she wasn't ready. After a period of talking through her peers and family, she gave in and decided to get her own.

3-Point System Installation and Sump Replacement

With radon levels testing over 30 pCi/L, this home required a three-point mitigation system to ensure proper pressure balance and effective radon reduction. Installation is scheduled with extraction points set near the airconditioning AC unit on the side of the home. During the project, our team will also replace the sump basin and install a new discharge line to improve drainage performance and system efficiency. These combined upgrades will help deliver long-term protection and healthier indoor air quality.

This installation was referred by one of satisfied clients, they needed help as their home does not have much space to place a system but they know we can work something out. We didn't disappoint once we saw the client's 3-chamber home. The client's crawlspace was decent enough to work with and did not give us a difficult time on how it should be placed. They even requested crawlspace encapsulation on the spot. Everything went well!

This was more complex than we thought it would be as we are looking to extract out of the utility room. Homeowner is finishing home and will like to run the PVC line along the listing ductwork and out through the rim joist and virtually how the PVC in the Sill plate. The team took some pictures and mark them up and read to indicate where he was thinking about running the pvc. He told me that he would have that existing pools cord and I told him that there was a slope that was needed and he said he would take that into account. The homeowner is a very DIY individual and has done a lot of good work on his home. He is going to core through his roof is sealed that up himself as he has done work on barns in the past and told us that it would be fine to just run the PVC up through and he would take it from there. This is because he has a metal roof. The third part of this is that the sump is in a finished area in the basement he will be lining it and throwing carpet over the top so we will need to seal up the sump with plexiglass instead of a dome lid so that he can finish over it. He is also left the discharge in the wall open to see if we needed to do anything with this. Homeowner said he would be available and present during the install, he's a super nice guy but wants to make sure that we're running it where we need to that way he can hide it and frame it out. He got the outcome he wanted.